Attach the Lanyard to the Marker

Each C Series Marker comes with two lanyards: a wrist and a neck lanyard. Both can be attached to the Marker in the same way, as follows:

 
  • Thread the loop of string at the end of the lanyard through the hole on the corner of the marker (closest to the 3.5 mm jack).
  • Once the loop is fully threaded through, pass the neck or wrist strap through the center of the loop.
  • Pull on the strap to tighten the loop and secure the lanyard to the Marker.
lanyard-diagram
  • Help us improve our Support Center. Was this article helpful?
  • Yes   No