Charging and Battery Life

The new C Series Robot looks similar to the Gen2 Robot, but can do a whole lot more!
Which robot do you have? The article you see here applies only to the Swivl C Series Robot. Click here for the Swivl Gen 2 Robot article.


 

The Swivl C Series base and marker are both powered by built-in rechargeable batteries.

Charging the Swivl base:

To charge the Swivl base, plug the wall charger into an outlet. Then plug the USB-side of the base charger into one of the USB outlets on the wall charger. Plug the other end of the base charger into the small circular outlet near the bottom of the base.

Charging the Swivl marker:

There are two ways to charge the marker:

 
  • Placing the marker in the back dock of the Swivl base.
  • Plugging the marker charging cable into the wall charger and into the 3.5mm jack on the side of the marker.
  stand-mode

Battery Life:

The Swivl C Series has a battery life of 5-6 hours under normal use cases.

When the Swivl Robot is fully set up with a compatible mobile device, you can check the percentage of battery left on either the base or marker from within the Swivl app settings.

Charging Setup:

The Swivl C5 Kit includes everything you need to charge the Swivl base, Primary Marker, all 4 Secondary Markers, and the mobile device all at once. An example of this charging setup can be seen below.

  charge-c5
  • Help us improve our Support Center. Was this article helpful?
  • Yes   No