String the Lens Clip to the Case

A nylon string is included with your Expand Lens to allow you to connect the lens to the case.

 

You can see the holes on both the lens and the case indicated in the graphics below.

  stand-mode stand-mode

In order to attach the string, follow these steps:

 
  • Pinch one end of the string, and thread it through the hole on the side of the Lens Clip.
  • Pull the string halfway through the hole.
  • Thread one side of the string into the loop created by the other side, and pull until the loop is tight.
  • Pinch the side of the string opposite the lens, and thread it through the hole on the case.
  • Pull the string through the hole, and tie off the string so that the knot sits inside the case.
  • Help us improve our Support Center. Was this article helpful?
  • Yes   No